LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 591 (Wiper System And Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If replacing reservoir, make sure to transfer all necessary components.
  1. Connect the washer level sensor electrical connector.
  2. Connect the washer pump electrical connector.
  3. Seat the washer hoses in the grooves on the washer bottle, and connect the hoses to the "T" connector at the motor.
  4. Set the solvent container in place on the vehicle, but do not install the fasteners.
    5. Fig 1: Front End Inner Side Panel Gusset
    GM833961Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the front end inner side panel gusset (2) and the fasteners retaining it to the vehicle.

    Tighten:  Tighten the fasteners to 25 N.m (18 lb ft).

  6. Install air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls 6.0L (LQ4).
  7. Fill the washer solvent container.
scientia non olet · About LEMON Manuals