LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Secondary And Configurable Customer Controls >> Diagnostic Information and Procedures >> Steering Wheel Controls Inoperative >> Component Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Testing

CAUTION: Refer to SIR Caution .
  1. Ignition OFF, disconnect the harness connector at the right steering wheel control switch.
  2. Test the for less than 2, 400 ohms between the ignition terminal 1 and the signal terminal 2.
    • If greater than the specified range, replace the steering wheel control switch.
  3. Test for infinite resistance between the ignition terminal 1 and the signal terminal 6 with the switch in the open position.
    • If not the specified range, replace the steering wheel control switch.
  4. Test the for less than 2, 400 ohms between the ignition terminal 1 and the signal terminal 6 with the switch in the closed position.
    • If greater than the specified range, replace the right steering wheel control switch.
  5. Disconnect the harness connector at the left steering wheel control switch.
  6. Test for infinite resistance between the signal terminal 1 and the signal terminal 5 with the switch in the open position.
    • If not the specified range, replace the steering wheel control switch.
  7. Test for less than 12, 000 ohms between the signal terminal 1 and the signal terminal 5 with the switch in the closed position.
    • If greater than the specified range, replace the steering wheel control switch.
scientia non olet · About LEMON Manuals