LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2007 >> H3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Positive Cable Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
    2. Fig 1: View Of Battery Cables
    GM1313634Courtesy of GENERAL MOTORS CORP.
  2. Open the protective cover (3) to access the battery positive cable terminal.
  3. Loosen the battery positive cable nut (4).
  4. Disconnect the battery positive cable from the battery.
    5. Fig 2: View Of Battery Tray, Battery Box & Battery Cable Harness Retainers
    GM1313637Courtesy of GENERAL MOTORS CORP.
  5. Open the battery cables harness retainers (3, 4).
    6. Fig 3: View Of Positive Cable At Underhood Fuse Block
    GM1313640Courtesy of GENERAL MOTORS CORP.
  6. Press the locking tabs inward in order to remove the underhood fuse block cover from the underhood fuse block.
  7. Remove the nut (3) securing the battery positive cable (4) to the underhood fuse block (1).
  8. Remove the battery positive cable (4) from the upper portion of the battery cables harness conduit (6).
  9. Raise and support the vehicle only high enough to access the remainder of the cable through the wheelhouse. Refer to Lifting and Jacking the Vehicle in General Information.
  10. Remove the left wheelhouse liner. Refer to Wheelhouse Liner Replacement - Front in Body Front End.
    11. Fig 4: View Of Battery Positive Cable At Starter
    GM1313639Courtesy of GENERAL MOTORS CORP.
  11. Remove the starter terminal nut (1) and disconnect the battery positive cable (2) from the starter.
    12. Fig 5: View Of Battery Positive Cable At Battery Cables Harness Conduit
    GM1313638Courtesy of GENERAL MOTORS CORP.
  12. Open the battery cables harness retainer (5) at the engine wiring harness bracket (1).
  13. Remove the battery positive cable (2) from the battery cables harness conduit (6).
scientia non olet · About LEMON Manuals