Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Starter Motor

Courtesy of GENERAL MOTORS CORP.

Position the starter motor (3) over the stud (2).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the starter motor mounting nut (1) and bolt (4).
Tighten: Tighten the starter motor mounting fasteners to 50 N.m (37 lb ft).

Fig 2: View Of Battery Positive Cable At Starter

Courtesy of GENERAL MOTORS CORP.

Connect the battery positive cable (2) to the starter and install the starter terminal nut (1)
Tighten: Tighten the battery positive cable to starter terminal nut to 9 N.m (80 lb in).
Connect the lead (4) to the starter solenoid and install the starter solenoid S terminal nut (3).
Tighten: Tighten the starter solenoid S terminal nut to 3.5 N.m (31 lb in).
Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical - 2.8L (LK5) orIntake Manifold Replacement in Engine Mechanical - 3.5L (L52).