LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H2 4D Utility Pickup >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls And Fuel - 6.2L - DTC P0010 To DTC P0232 >> DTC P0230 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. With the ignition OFF, disconnect the harness connector at the FPCM.
  2. With the ignition ON, engine OFF, probe the control circuit of the fuel pump control module terminal 13 with a test lamp that is connected to a good ground. Command the fuel pump ON and OFF with a scan tool. The test lamp should turn ON and OFF with each command.
    • If the test lamp does not turn ON and OFF, test for an open, high resistance, or a short to ground in the fuel pump relay control circuit, an intermittent or a poor connection at the engine control module (ECM). If the circuit tests normal, replace the control module.
    • If the test lamp remains illuminated with each command, test for a short to voltage in the control circuit of the fuel pump relay or an intermittent or a poor connection at the ECM. If the circuit tests normal, replace the control module.
  3. If all circuits test normal, replace the FPCM.
scientia non olet · About LEMON Manuals