Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Washer Solvent Level Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Open the hood.
Remove the washer solvent from the washer solvent container.
Disconnect the washer solvent level sensor (6) electrical connector.
Remove the A/C low pressure switch. Refer to Air Conditioning (A/C) Low Pressure Switch Replacement .
Mark the location of the sensor prior to removal.

Fig 2: Level Sensor

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The level sensor arm hinges at the point called out (1). Before servicing the level sensor, it is necessary to get the level sensor arm in a horizontal position. Failure to do so will result in breakage of the level sensor.

Get the level sensor in a horizontal position by inserting a long, narrow tool through the washer solvent fill hole, and gently raising the sensor arm.

Fig 3: Washer Solvent Container Level Sensor

Courtesy of GENERAL MOTORS CORP.

Remove the level sensor from the washer solvent container.