LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H2 4D Utility Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Antilock Brake System With TCS) >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EBCM To BPMV Screws
    GM213438Courtesy of GENERAL MOTORS CORP.
  1. Connect the pump motor connector (3) to the bottom of the EBCM.
  2. Install the EBCM (1) to the BPMV (4).
    3. NOTE: Refer to Fastener Notice .
  3. Install the 6 retainers (2) which connect the EBCM to the BPMV.

    Tighten:  Tighten the retainers to 2.9 N.m (26 lb in).

  4. Connect the EBCM harness connector.
  5. Lower the vehicle.
  6. Turn the ignition switch to the RUN position. Do NOT start the engine.
  7. Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle .
  8. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals