LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H2 4D Utility Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Antilock Brake System With TCS) >> Repair Instructions >> Front Wheel Speed Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Brake/Hub Components
    GM379487Courtesy of GENERAL MOTORS CORP.
  1. Install the WSS (5) into the hub/bearing assembly (4).
    2. NOTE: See Fastener Notice
  2. Install the WSS mounting bolt.

    Tighten:  Tighten the WSS mounting bolt to 18 N.m (13 lb ft).

    3. Fig 2: View Of Wheel Speed Sensor Cable And Connectors
    GM913362Courtesy of GENERAL MOTORS CORP.
  3. Install the WSS cable mounting clip to the knuckle.
  4. Install the WSS cable mounting clip to the upper control arm.
  5. Install the WSS cable mounting clip to the frame attachment point.
  6. Connect the WSS cable electrical connector.
  7. Install the brake rotor. Refer to Front Brake Rotor Replacement .
  8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  9. Return to Diagnostic Starting Point - Antilock Brake System .
scientia non olet · About LEMON Manuals