Initialization Sequence
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
The EBCM performs 1 initialization test each ignition cycle. The initialization of the EBCM occurs when both of the following conditions occur:
- The EBCM detects that there is a minimum of 500 RPM from the PCM via a serial data message.
- The brake pedal is not applied.
OR
The vehicle speed is greater than 16 km/h (10 mph).
The initialization sequence cycles each solenoid valve and the pump motor, as well as the necessary relays, for approximately 1.5 seconds to check component operation. The EBCM sets a DTC if any error is detected. The initialization sequence may be heard and felt while it is taking place, and is considered part of normal system operation.
The EBCM defines a drive cycle as the completion of the initialization sequence.