LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Alpha >> Repair and Diagnosis >> External Pages >> Different car >> Section 230 (Engine Controls And Fuel - 4.4L - Introduction) >> Repair Instructions >> Primary Fuel Level Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Gasoline/Gasoline Vapors Caution .
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Remove the primary fuel tank module. Refer to Primary Fuel Tank Module Replacement .
    3. Fig 1: View Of Primary Fuel Level Sensor Electrical Connector
    GM820628Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the fuel level sensor electrical connector (1) from the module.
    4. Fig 2: View Of Fuel Level Sensor & Locking Tab
    GM820629Courtesy of GENERAL MOTORS CORP.
  4. Complete the following in order to remove the fuel level sensor (1) from the module assembly:
    1. Pull the locking tab (2) away from the sensor (1).
    2. Slide the sensor (1) away from the module assembly.
scientia non olet · About LEMON Manuals