LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 300 (Disc Brake System) >> Repair Instructions >> Brake Caliper Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper
    GM2128790Courtesy of GENERAL MOTORS CORP.
  1. Install the brake caliper (1).
    2. CAUTION: Refer to Fastener Caution .
    Fig 2: Brake Caliper Guide Pin Bolts
    GM2128789Courtesy of GENERAL MOTORS CORP.
  2. Install the brake caliper guide pin bolts (1) and tighten to 64 N.m (47 lb ft).
    3. NOTE: Install new brake hose fitting gaskets.
    Fig 3: Identifying Brake Hose & Fittings
    GM2128788Courtesy of GENERAL MOTORS CORP.
  3. Assemble the brake hose fitting bolt (1) and new brake hose fitting gaskets (2) to the brake hose fitting (3).
  4. Install the brake hose assembly to the brake caliper and tighten the fitting bolt to 40 N.m (30 lb ft).
  5. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals