Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front drive axle, if equipped. Refer to Differential Carrier Assembly Replacement .
Remove the lower control arm. Refer to Lower Control Arm Replacement (2WD, Z85, ZQ8) .

Fig 1: View Of Rear Bushing

Courtesy of GENERAL MOTORS CORP.

Before removing the bushing, measure and record the distance from the bushing flange to the bracket. This will be the distance that the new bushing will be installed to.

Fig 2: Identifying J 41805

Courtesy of GENERAL MOTORS CORP.

Using the J 41805 (1), remove the rear bushing. See Special Tools .