LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2009 >> H3 Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Cellular, Entertainment, And Navigation >> Repair Instructions >> Digital Radio Receiver Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: View Of Receiver & Mounting Bracket
    GM1364133Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. If replacing the receiver, install the receiver to the mounting bracket and install the retaining nuts.

    Tighten:  Tighten the nuts to 3 N.m (26 lb in).

    2. Fig 2: View Of Electrical Connector Release Lever & CPA
    GM1408373Courtesy of GENERAL MOTORS CORP.
  2. Position the receiver to the I/P.
  3. Connect the receiver electrical connectors.
  4. Install the CPA (2) to the electrical connector.
    5. Fig 3: View Of Digital Radio Receiver
    GM1364140Courtesy of GENERAL MOTORS CORP.
  5. Install the receiver to the I/P.
    6. Fig 4: View Of Digital Radio Receiver Retaining Screws
    GM1364138Courtesy of GENERAL MOTORS CORP.
  6. Install the screws retaining the digital radio receiver to the I/P structure.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

    7. Fig 5: View Of Service Panel
    GM1364141Courtesy of GENERAL MOTORS CORP.
  7. Close the service panel located above the I/P compartment door.
  8. Install the I/P compartment door. Refer to Instrument Panel Compartment Door Replacement .
  9. Install the I/P outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement - Right Side (Right Hand Drive) or Instrument Panel Outer Trim Cover Replacement - Right Side (Left Hand Drive) .
  10. For programming and set up, Refer to Control Module References .
scientia non olet · About LEMON Manuals