LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2009 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 5.3L - Introduction) >> Repair Instructions >> Knock Sensor 1 Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Wiring Harness Electrical Connector & Crankshaft Position (CKP) Sensor Wire Harness
    GM1899640Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the engine wiring harness electrical connector (2) from the knock sensor (1).
    3. Fig 2: Left Side Knock Sensor & Bolt
    GM1402136Courtesy of GENERAL MOTORS CORP.
  3. Remove the knock sensor bolt (739) and sensor (718).
scientia non olet · About LEMON Manuals