LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis (Single Page) >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Lower Intermediate Steering Shaft Replacement >> Installation Procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Installation Procedure

  1. Perform the following procedure before installing the lower and upper intermediate steering shaft bolts:
    1. Remove all traces of the original adhesive patch.
    2. Clean the threads of the bolt with denatured alcohol, or equivalent, and allow to dry.
    3. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488) or blue, medium LOCTITE™ 242.
  2. Position the lower intermediate steering shaft to the vehicle.
  3. Connect the lower intermediate steering shaft to the steering gear.
    4. Fig 1: Lower Intermediate Steering Shaft Bolt
    GM2092822Courtesy of GENERAL MOTORS CORP.
  4. Install the lower intermediate steering shaft bolt (1) at the steering gear.

    Tighten:  Tighten the bolt to 45 N.m (33 lb ft).

  5. Connect the lower intermediate steering shaft to the upper intermediate steering shaft.
    6. Fig 2: Upper Intermediate Steering Shaft Bolt
    GM2092820Courtesy of GENERAL MOTORS CORP.
  6. Install the upper intermediate steering shaft bolt (1).

    Tighten:  Tighten the bolt to 23 N.m (17 lb ft).

  7. Remove anti-rotation pin J 42640  .
scientia non olet · About LEMON Manuals