LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2010 >> H3T Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System & Fuel System - 3.7L - Repair Instructions) >> Repair Instructions >> Crankshaft Position System Variation Learn >> Crankshaft Position System Variation Learn Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position System Variation Learn Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a scan tool.
  2. Monitor the ECM for DTCs with a scan tool. If other DTCs are set, except DTC P0315, refer to Diagnostic Trouble Code (DTC) List - Vehicle for the applicable DTC that set.
  3. With a scan tool, select the CKP system variation learn procedure and perform the following:
    1. Observe the fuel cut-off for the applicable engine.
    2. Block the drive wheels.
    3. Set the parking brake.
    4. Place the vehicle's transmission in Park or Neutral.
    5. Turn the air conditioning (A/C) OFF.
    6. Cycle the ignition from OFF to ON.
    7. Apply and hold the brake pedal for the duration of the procedure.
    8. Start and idle the engine.
    9. Accelerate to wide open throttle (WOT). The engine should not accelerate beyond the calibrated fuel cut-off RPM value noted in step 3.1. Release the throttle immediately if the value is exceeded.
      10. IMPORTANT: While the learn procedure is in progress, release the throttle immediately when the engine starts to decelerate. The engine control is returned to the operator and the engine responds to throttle position after the learn procedure is complete.
    10. Release the throttle when fuel cut-off occurs.
  4. The scan tool displays Learn Status: Learned this Ignition. If the scan tool indicates that DTC P0315 ran and passed, the CKP variation learn procedure is complete. If the scan tool indicates DTC P0315 failed or did not run, refer to DTC P0315 . If any other DTCs set, refer to Diagnostic Trouble Code (DTC) List - Vehicle for the applicable DTC that set.
  5. Turn OFF the ignition for 30 seconds after the learn procedure is completed successfully.
scientia non olet · About LEMON Manuals