LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 1986 >> Excel Base, 4D Hatchback >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Ignition System - Electronic >> Overhaul >> Disassembly >> Excel 1.5L
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Excel 1.5L

  1. Remove distributor cap, rotor and seal. Remove governor assembly. Remove vacuum control unit. Remove IC ignitor. Remove lead wire. Remove signal rotor shaft screw and 2 breaker plate retaining screws. Remove breaker plate assembly.
    NOTE: DO NOT clean grease off back of IC ignitor. It is necessary for heat transfer.
  2. Remove signal rotor shaft from signal rotor. Remove 2 spring retainers and springs with pliers. Remove governor weights. Mark drive gear location on distributor shaft.
  3. Place drive gear on a wooden block and remove drive gear roll pin using a pin punch. Remove drive gear and washer. Remove distributor shaft from housing.
Fig 1: Installing Driven Gear on Distributor Shaft Align marks and install new roll pin.
G34230
scientia non olet · About LEMON Manuals