Component Testing: Switch

Remove switch in question and perform continuity testing according to appropriate table. Main switch is driver's switch. Sub-switches are mounted at each passenger door.

Fig 1: Identifying Sub-witch Connectors (Scoupe)

Courtesy of HYUNDAI MOTOR CO.

Fig 2: Power Window Relay Switch Connector ID (Component Side)

Courtesy of HYUNDAI MOTOR CO.

CONTINUITY TESTING MAIN SWITCH ⁽¹⁾

Position

Condition

⁽²⁾ Terminals

Left

No. 1 & 3; 4 & 7

Off

No. 1, 3 & 7

Down

No. 1 & 7; 3 & 4

Right

No. 1 & 2; 5 & 6

Off

No. 1, 2 & 5

Down

No.1 & 5; 2 & 6

⁽¹⁾	Disconnect switch before testing. Check continuity between terminals. If continuity does not exist as shown, replace switch.

⁽²⁾	SeeFig 1 and Fig 2 .

CONTINUITY TESTING SUB-SWITCH ⁽¹⁾ , ⁽²⁾

Position

⁽³⁾ Terminals

No. 2 & 4; 3 & 5

Off

No. 1 & 2; 3 & 5

Down

No. 1 & 2; 4 & 5

⁽¹⁾	Disconnect switch before testing. Check continuity between terminals. If continuity does not exist as shown, replace switch.

⁽²⁾	Continuity between terminals No. 1 and 4 with switch in ON position, and no continuity with switch in OFF position.

⁽³⁾	SeeFig 1 and Fig 2 .