Component Tests: Sub-Switch

NOTE: Sub-switch is incorporated into multifunction switch. If sub-switch is defective, multifunction switch assembly must be replaced.

Disconnect multifunction switch harness connector. Check continuity between switch terminals with switch in specified position. See SUB-SWITCH CONTINUITY table. See Fig 1 or Fig 2 . If switch does not test as specified, replace multifunction switch.

SUB-SWITCH CONTINUITY

Switch Position

Continuity Between Terminals No.

SET/COAST

Elantra

6 & 10

Sonata

11 & 17

Tiburon

With EPS ⁽¹⁾

16 & 17

Without EPS ⁽¹⁾

6 & 10

RESUME/ACCEL

Elantra

7 & 10

Sonata

11 & 18

Tiburon

With EPS ⁽¹⁾

13 & 16

Without EPS ⁽¹⁾

7 & 10

⁽¹⁾	Electronic Power Steering (EPS).

Fig 1: Identifying Multifunction Switch Connector (Elantra & Tiburon - Without EPS)

Courtesy of HYUNDAI MOTOR CO.

Fig 2: Identifying Multifunction Switch Connector (Sonata & Tiburon - With EPS)

Courtesy of HYUNDAI MOTOR CO.