Specifications Index
ACCENT SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | N/A | ||
| Battery | N/A | ||
| Axle Nut/Hub Nut | 148-192 Ft. Lbs. (200-260 N.m) | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | BLEEDING PROCEDURE | ||
| Without ABS | BLEEDING PROCEDURES | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | GENERATOR OUTPUT TEST | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT TENSION INSPECTION & ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 11-15 psi | ||
| Thermostat R & I | N/A | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION | ||
| Oil Pressure | Normal oil pressure is at least 21.33 psi (1.5 kg/cm2 ) at curb idle with oil temperature of 167-203°F (75-95°C). | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Drive Plate/Flex Plate | 96-103 Ft. Lbs. (130-140 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | In left rear corner of engine compartment, below brake master cylinder. | ||
| Fuel Pressure Release Procedure | ACCENT, ELANTRA & TIBURON | ||
| Fuel Pressure Specifications | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH-TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER & TIMING MARKS . Data may be included in existing Figures. | ||
| Spark Plugs | SPARK PLUGS | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 66-81 Ft. Lbs. (90-110 N.m) | ||