Specifications Index
ACCENT SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | N/A | ||
| Axle Nut/Hub Nut | 148-192 ft. lbs. (200-260 N.m) | ||
| Battery | N/A | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | BLEEDING PROCEDURE | ||
| Without ABS | BLEEDING PROCEDURES | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | See GENERATOR OUTPUT SPECIFICATIONS table under GENERATOR OUTPUT TEST . | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | DRIVE BELT TENSION ADJUSTMENT | ||
| Belt Routing | REMOVAL & INSTALLATION | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 11-15 psi | ||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | |||
| 1.5L | ENGINE SPECIFICATIONS | ||
| 1.6L | SPECIFICATION | ||
| Oil Pressure | Normal oil pressure is 21.33 psi (1.5 kg/cm2 ) at curb idle with oil temperature of 194-215°F (90-100°C) for 1.6L engines or 167-203°F (75-95°C) for 1.5L engines. | ||
| Overhaul | |||
| 1.5L | ENGINE SPECIFICATIONS | ||
| 1.6L | SPECIFICATION | ||
| Torque | |||
| 1.5L | TORQUE SPECIFICATIONS | ||
| 1.6L | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | 96-103 ft. lbs. (130-140 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | Above Fuel Tank, Next To Sender. See FUEL FILTER . | ||
| Fuel Filter R & I | FUEL FILTER | ||
| Pressure Specification | FUEL PUMP TEST | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||
| Fuel Pressure Release Procedure | FUEL PRESSURE RELEASE | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH-TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER & TIMING MARKS . Wire routing may be located in Figure. | ||
| Spark Plugs | SPARK PLUGS | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Lug Nut Torque | 66-81 ft. lbs. (90-110 N.m) | ||