LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2003 >> Accent Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle System) >> Automatic Transaxle System >> Automatic Transaxle >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Automatic Transaxle: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Attach the torque converter on the transaxle side and mount the transaxle assembly onto the engine.
    CAUTION:
    • If the torque converter is mounted on the engine first, the oil seal on the transaxle side may be damaged. Therefore, be sure to first assemble the torque converter to the transaxle.
    • When installing the roll stopper mounting bracket, be careful not to crush the insulator. If crushed, idle vibration may occur.
  2. Install the transaxle control cable and adjust as follows:
    1. Move the shift lever and the transaxle range switch to the "N" position and install the control cable.
    2. When connecting the control cable to the transaxle mounting bracket, install the clip until it contacts to the control cable.
    3. Remove any free-play in the control cable by adjusting the nut and then check to see that the selected lever moves smoothly.
    4. Check to see that the control cable has been adjusted correctly.
scientia non olet · About LEMON Manuals