LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2003 >> XG350 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> Diagnostic Tests >> DTC P0222: Throttle Position Sensor B Circuit Low Input >> Scantool Diagnostics >> Monitor Scantool Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor Scantool Data

  1. Install Scantool and monitor the "TPS 1 (Main) or TP Sensor (ETS)" parameter on scantool.
    1. Test Condition: Ignition "ON" & Engine "OFF".
    2. Specification:

    Throttle valve fully closed: approx. 0.1~1.0V

    Throttle valve fully open: approx. 4.0~4.7V

    TPS signal should increase smoothly as throttle is opened.

    Fig 1: TPS Signal Waveform At Accelerating And Decelerating - 1 TPS2 And TPS1
    G07377977
    Fig 2: Scantool Display - TPS Signal Output With Throttle Valve Fully Closed
    G07377978
    Fig 3: Scantool Display - TPS Signal Output With Throttle Valve Fully Open
    G07377979
  2. Is TPS signal within specifications?

    YES

    • Fault is intermittent caused by poor contact in the sensor's and/or ETS unit's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO