MFI Control System: Injector: Installation

WARNING: This page is about a different car, the 2004 Hyundai XG350. However, it is still accessible from the selected car via links, so may be relevant.

Install a new grommet and O-ring to the injector.
Apply a coating of solvent, spindle oil or gasoline to the injector O-ring.

Fig 1: Identifying Injector O-Rings
Courtesy of HYUNDAI MOTOR CO.
While turning the injector left and right, install it onto the delivery pipe.
Be sure the injector turns smoothly.
NOTE: If injector does not turn smoothly, the O-ring may be jammed. Remove the injector and re-insert it into the delivery pipe and re-check.

Fig 2: Installing Injector
Courtesy of HYUNDAI MOTOR CO.