Monitor DTC Status

This is the inspection procedure to determine whether it is present DTC or memoried one by monitoring the current signal or by using the function of oscilloscope with Hi-scan pro.

1. Connect scan tool to Data Link Connector (DLC).
2. Warm up the engine to normal operating temperature.
3. Monitor the "CURRENT DATA" parameter on the scan tool.
   Fig 1: Monitoring "CURRENT DATA" Parameter On Scan Tool

   Courtesy of HYUNDAI MOTOR CO.
4. Is parameter displayed within specifications?

   YES 

   • Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedures.

   NO 

   • Go to "W/HARNESS INSPECTION" procedure.