Power Circuit Inspection

Check for open in harness at Memory power input
1. Ignition "OFF"
2. Connect PCM connector.
3. Ignition "ON" & Engine "OFF"
4. Measure voltage between terminal 12 of PCM harness connector and chassis ground.
  Specification: approximately B+
  
  Fig 1: Measuring Voltage Between Terminal 12 Of PCM Harness Connector And Chassis Ground
  Courtesy of HYUNDAI MOTOR CO.
5. Is measure voltage within Specification?
  YES
  - Go to "COMPONENT INSPECTION " procedure
  NO
  - Open or short circuit to chassis ground between PCM harness connector and Control relay ON input circuit.
  - Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.