KICKDOWN Servo Adjustment
WARNING: This page is about a different variant/trim than selected.
- Completely remove all dirt and other contaminating materials adhered around the kickdown adjust screw.
- Loosen the lock nut.
- Loosen and tighten the adjust screw two times by torque of 5 Nm (3.6 lb.ft)
- Tighten adjust screw by torque of 5 Nm and then, loosen the adjust screw 3 to 3-1/3 turns.
- Tighten the lock nut to the specified torque.
Lock nut: 15~22 Nm (150~220 kg.cm, 11~16 lb.ft)
NOTE:
Before assembling, apply sealant (DC780) to the center portion of the adjust screw.