Signal Circuit Inspection

Check voltage of TPS.
1. Ignition "OFF".
2. Disconnect TP sensor connector.
3. Measure voltage between terminal 3 of TP sensor harness connector and chassis ground.
  Specification: Approx. 0V
  
  Fig 1: Measuring Voltage Between Terminal 3 Of TP Sensor Harness Connector And Chassis Ground
4. Is the measured voltage within specifications?
  YES
  - Go to " 2 Check for open in harness" as below.
  NO
  - Check for short to battery in harness.
  - Repair or replace as necessary. And then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check for open in harness.
1. Ignition "OFF".
2. Disconnect TP sensor connector and PCM connector.
3. Measure resistance between terminal 3 of TP sensor harness connector and terminal 8/C21-3 of PCM harness connector.
  Specification: Approx. below 1Ω
  
  Fig 2: Measuring Resistance Between Terminal 3 Of TP Sensor And Terminal 8/C21-3 Of PCM Harness Connector
4. Is the measured resistance within specifications?
  YES
  - Go to "GROUND CIRCUIT INSPECTION " procedure.
  NO
  - Check open in harenss between TPS connector and PCM connector.
  - Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.