Inspection Procedures

1. CHECK DTC RELATING TO FTPS/PCSV
   1. Connect Hi-Scan (Pro) to data link connector.
   2. Turn ignition to ON and monitor other DTCs.

   Is any DTC relating to FTPS or PCSV set? 

   No: Go to next

   Yes: Do all repairs associated with those codes before proceeding with this procedure.

2. CHECK FTPS/PCSV FOR CONNECTOR CONDITION
   1. Turn ignition switch to OFF.
   2. Thoroughly check connectors for loose, bent, corroded, contaminated, deteriorated or damaged connectors.

   Is any problem present? 

   No: Go to next

   Yes: Repair or replace it.

3. CHECK FTPS FOR NORMAL PARAMETER
   1. Install FTPS and monitor FTPS voltage signal.
   • Specification: approximately 2.5V at idle 

   Is voltage within specifications? 

   Yes: Go to next

   No: Replace FTPS.

4. CHECK PCSV
   1. Disconnect PCSV connector and EVAP hose (PCSV side) between PCSV and canister.
   2. Check vacuum at PCSV.
   • Refer to  EVAPORATIVE (EVAP) CANISTER PURGE SOLENOID VALVE  . 

Is PCSV normal? 

Yes: Proceed with ECM PROBLEM PROCEDURE  .

No: Replace it.