April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

Ignition "OFF".
Disconnect Fuel Level Sensor connector.

Measure resistance between terminal "1" and "3" of the Fuel Level Sensor connector during lifting fuel float up and down (To Component Side).

FLS SPECIFICATIONS

FLS	Normal Parameter
Float position	Full gauge	3/4	1/2	1/4	Empty gauge
Resistance	8Ω	36Ω	66Ω	110Ω	200Ω
Fuel volume	68l	52l	38l	23l	5l

Fig 1: Measuring Resistance Between Terminal 1 And 3 Of Fuel Level Sensor Connector

G07374663

Is the measured resistance of Fuel Level Sensor within specifications?
YES
- Substitute with a known - good PCM and check for proper operation.
  If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good Fuel Level Sensor and check for proper operation.
  If the problem is corrected, replace Fuel Level Sensor and go to "VERIFICATION OF VEHICLE REPAIR " procedure.