April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

Ignition "OFF".
Disconnect Fuel Level Sensor connector.

Measure resistance between terminal 1 and 3 of the Fuel Level Sensor connector during lifting fuel float up and down (To Component Side).

FLS REFERENCE CHART

FLS	Normal Parameter
Float position	Full gauge	3/4	1/2	1/4	Empty gauge
Resistance	8Ω	36Ω	66Ω	110Ω	200Ω
Fuel volume	68l	52l	38l	23l	5l

Fig 1: Measuring Resistance Between Terminal 1 And 3 Of Fuel Level Sensor Connector During

G07375515

Is the measured resistance of Fuel Level Sensor within specifications?
YES
- Substitute with a known - good PCM and check for proper operation.
  If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good Fuel Level Sensor and check for proper operation.
  If the problem is corrected, replace Fuel Level Sensor and go to "VERIFICATION OF VEHICLE REPAIR " procedure.