LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2006 >> Accent Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (A4AF3) >> Automatic Transaxle System >> DTC P1709 Kick Down Switch >> Monitor SCANTOOL Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor SCANTOOL Data

  1. Connect scantool to data link connector(DLC).
  2. Engine "ON".
  3. Monitor the "K/D SWITCH" parameter on the scantool.
  4. Operate the vehicle from "1st" gear to "4th" gear.
    Fig 1: Scan Tool Display - K/D Switch
    G04802141Courtesy of HYUNDAI MOTOR CO.
  5. Does "K/D SWITCH" follow the reference data?

    YES  : --> Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO  : --> Go to "TERMINAL & CONNECTOR INSPECTION " procedure.

scientia non olet · About LEMON Manuals