SRS Control Module: Installation
- Disconnect the battery negative cable and wait for at least three minutes before beginning work.
- Remove the ignition key from the vehicle.
- Install the SRSCM with the SRSCM mounting bolts.
Tightening torque (SRSCM Mounting Bolt): 0.7 ~ 0.9 kgf.m (6.9 ~ 8.8 Nm, 5.1 ~ 6.5 lb.ft)
NOTE: Use new mounting bolts when replacing the SRSCM after a collision. - Connect the SRSCM harness connector.
- Install the heater ducts and floor console. (Refer to INTERIOR -- AZERA )
- Connect the DAB, PAB, SAB, CAB, BPT and BUPT connectors.
- Reconnect the battery negative cable.
- After installing the SRSCM, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.