Memory Replay Operation
- Data related to the memory replay are received through the CAN communication from DDM.
- Memory replay will not be performed unless it is registered.
- If the position switch is pressed while the memory replay is in operation, the final switch is effective. Though, if the switches are pressed within the time interval of 50 ms, replay will not be performed.
- When the replay is in operation (position switch is ON), buzzer will sounds once.
- If any of the following conditions is met, replay is prohibited and operation will stop if it is in replay.
When the ignition is OFF.
When the "P" position switch is OFF (when the shift lever is at the position other than "P")
When the vehicle speed is over 3 Km/h (when it last more than 2 or 3 seconds)
When the manual switch in relation to the tilt & telescope is in operation. (Tilt & telescope related replay operation stops)
When the stop switch is ON.
- Determining operational priority
In order to prevent overlapping of rushing current when the motor starts up, motor start-up is delayed for 100 ± 10 ms respectively and its operational priority is as follows.
Tilt > Telescope