LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2007 >> Azera GLS >> Repair and Diagnosis >> Transmission >> Automatic Transaxle System (A5HF1) >> Automatic Transaxle System >> Service Adjustment Procedure >> DTC P0717 Input Speed Sensor Circuit - No Signal >> Monitor SCANTOOL Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor SCANTOOL Data

  1. Connect scan tool to data link connector (DLC).
  2. Engine "ON".
  3. Monitor the "INPUT SPEED SENSOR" parameter on the scantool.
  4. Driving at speed of over 19 Mile/h (30 Km/h).

    Specification: Increasing Gradually

    Fig 1: Scan Tool Display - Input Speed Sensor Parameter
    G04880096Courtesy of HYUNDAI MOTOR CO.
  5. Does "Input speed sensor" follow the reference data?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals