LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2007 >> Entourage GLS >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis (2 Of 2) >> DTC Troubleshooting Procedures >> DTC P2271 O2 Sensor Signal Stuck Rich (Bank 1 / 2 Sensor 1) >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. Check the condition of HO2S
    1. Check HO2S for poor connection or loose terminal.
    2. Check if HO2S is ensurely installed.
    3. Is the conditions of HO2S normal ?

      YES 

      • Go to " 2Check the Signal waveform of HO2S" as follows.

      NO 

  2. Check the Signal waveform of HO2S
    1. IG "OFF" and connect HO2S connector.
    2. Engine start.
    3. After warming-up, monitor signal waveform of HO2S with scantool.
      Fig 1: HO2S Terminals Waveform Signal Reference On Scantool
      G05322212Courtesy of HYUNDAI MOTOR CO.
    4. Is the sensor switching properly?

      YES 

      • Go to "Check fuel filter " as follows.

      NO 

      • Substitute with a known - good HO2S and check for proper operation. If the problem is corrected, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. Before or after testing PCM on the vehicle, use this function to reuse the PCM on the others
scientia non olet · About LEMON Manuals