LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2007 >> Entourage GLS >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Transaxle System (A5HF1) >> Automatic Transaxle System >> DTC P0707 Transaxle Range Switch - Low Input >> Monitor SCANTOOL Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor SCANTOOL Data

  1. Connect scantool to data link connector (DLC).
  2. Ignition "ON" & Engine "OFF".
  3. Monitor the "TRANSAXLE RANGE SWITCH" parameter on the scantool.
  4. Shift selector lever from "P" range to other range.
    Fig 1: Monitor Scantool Data - Transaxle Range Switch
    G04880079Courtesy of HYUNDAI MOTOR CO.
  5. Does "TRANSAXLE RANGE SWITCH" follow the reference data?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals