Component Inspection
- Check resistance of OTS
- IG "ON" & ENG "OFF"
- Monitor Oil Temperature parameter on the scantool
- IG "OFF" & ENG "OFF"
- Disconnect OTS connector.
- Measure resistance between terminal 1 and 2 of OTS connector (Component Side)
SPECIFICATION:
SPECIFICATIONTemperature (°C/°F) Resistance (kΩ) -20 °C/ -4°F 16.52kΩ 20 °C/ 68°F 2.45kΩ 80 °C/ 176°F 0.29kΩ - Is the measured resistance within specification ?
YES
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good OTS and check for proper operation. If the problem is corrected, replace OTS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.