LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2007 >> Entourage GLS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC Troubleshooting Procedures >> DTC P0325 Knock Sensor 1 Circuit; DTC P0330 Knock Sensor 2 Circuit >> Signal Circuit Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Signal Circuit Inspection

  1. Check open in harness
    1. IG "OFF" and disconnect knock sensor connector and PCM connector.
    2. [P0325] Measure resistance between terminal 1 of knock sensor harness connector and terminal 55 of PCM harness connector.

      [P0330] Measure resistance between terminal 1 of knock sensor harness connector and terminal 54 of PCM harness connector.

    3. [P0325] Measure resistance between terminal 2 of knock sensor harness connector and terminal 56 of PCM harness connector.

      [P0330] Measure resistance between terminal 2 of knock sensor harness connector and terminal 53 of PCM harness connector.

      Specification : Below 1Ω

    4. Is the measured resistance within specification?

      YES 

      • If the problem is corrected after substituting with a known - good knock sensor, replace it. If the problem is pending, check for proper operating after substituting with a known - good PCM. and then if the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

    NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others
scientia non olet · About LEMON Manuals