LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2007 >> Entourage SE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (2 Of 2) >> DTC Troubleshooting Procedures >> DTC P0462 Fuel Level Sensor "A" Circuit Low Input >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. Ignition "OFF"
  2. Disconnect Fuel Level Sensor connector and Remove Fuel Sender from fuel tank.
  3. Measure resistance between terminal 3 and 6 of Fuel Sender. (Component Side)
    Fig 1: Measuring Resistance Between Terminal 3 And 6 Of Fuel Sender (Component Side)
    G05322096Courtesy of HYUNDAI MOTOR CO.
  4. Does the resistance of FLS change with lifting up and down the fuel level float ?

    YES 

    • Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Substitute with a known - good Fuel Level Sensor and check for proper operation. If the problem is corrected, replace Fuel Level Sensor and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. Before or after testing PCM on the vehicle, use this function to reuse the PCM on the others
scientia non olet · About LEMON Manuals