Ground Circuit Inspection

Check open in harness
1. IG "OFF".
2. Disconnect APS connector.
3. Measure voltage between terminal 6 of APS harness connector and chassis ground. (Fig. A)
4. Measure voltage between terminal 6 and 5 of APS harness connector. (Fig. B)
  Specification : Fig. "A" - Fig. "B" = approx. below. 200mV.
5. Is the measured voltage within specification ?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Repair or replace contact resistance or open in harness and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.