Control Circuit Inspection

Check for open in harness
1. Ignition "OFF"
2. Disconnect SMARTRA.
3. Ignition "ON" & Engine "OFF"
4. Measure voltage value between terminal C30-A-72 (2.7) or C130-A-72 (3.3) and chassis ground.
  Specification : Approx. 11V
  
  Fig 1: Measuring Voltage Value Between Terminal C30-A-72 (2.7) Or C130-A-72 (3.3) And Chassis Ground - Gasoline 2.7
  Courtesy of HYUNDAI MOTOR CO.
  
  Fig 2: Measuring Voltage Value Between Terminal C30-A-72 (2.7) Or C130-A-72 (3.3) And Chassis Ground - Gasoline 3.3
  Courtesy of HYUNDAI MOTOR CO.
5. Is the measured voltage within specifications?
  YES
  
  Go to "COMPONENT INSPECTION " procedure
  
  NO
  
  Check for open or short in harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.