DTC Description

PCM sets DTC P0113 if the PCM detects signal voltage higher than the possible range of a properly operating IATS.

DTC DETECTING CONDITION CHART

Item	Detecting Condition	Possible Cause
DTC Strategy	Voltage range check	Short to battery in signal harness Open in signal or ground circuit Contact resistance in connections Faulty IAT sensor
Enable Conditions	6 < Battery voltage < 16V Time after start in case of SCB or OL: 110 sec
Threshold Value	Measured intake air temperature < -46°C (-51°F)
Diagnostic Time	5 seconds
Fail Safe	No failure detected on ECTS The limp home value of IATS depends on engine coolant temperature. Failure detected on ECTS. PCM controls with mapping data.
Mil On Condition	2 Driving Cycles