SRS Control Module: Installation
- Remove ignition key from the vehicle.
- Disconnect the negative (-) cable from battery and wait for at least three minutes.
- Install the SRSCM with the SRSCM mounting nuts.
Tightening Torque (SRSCM Mounting Bolt) :
0.7 ~ 0.9 kgf.m (7 ~ 9 Nm, 5.2 ~ 6.6 lb.ft)
- Connect the SRSCM harness connector.
- Install the floor console. (Refer to BUMPER )
- Connect the DAB, PAB, SAB and BPT connectors.
- Reconnect the battery negative cable.
- After installing the SRSCM, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.