Check Short To Battery In Harness
- IG "OFF" and disconnect ETC Motor & TPS connector and PCM connector.
- Measure resistance between TPS2 signal and TPS1 power terminals of ETC Motor & TPS harness connector. (Measurement "A")
- Measure resistance between TPS2 signal and TPS2 power terminals of ETC Motor & TPS harness connector. (Measurement "A")
- Measure resistance between TPS2 signal and ETC motor (+) terminals of ETC Motor & TPS harness connector. (Measurement "B")
- Measure resistance between TPS2 signal and ETC motor (-) terminals of ETC Motor & TPS harness connector. (Measurement "B")
Specification : Infinite
- Is the measured resistance within specification?
YES:
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO:
- Repair short to battery in harness, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.