April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

Check Main Relay

IG "OFF".
Disconnect Main Relay
Measure resistance between terminal 5 and 3 of Main Relay

Measure resistance between terminal 4 and 2 of Main Relay.

Specification:

SPECIFICATION CHART

Terminal	Power approval
3 ~ 5	NO
2 ~ 4	YES (Approx. 70Ω ~ 120Ω)

Fig 1: Measuring Resistance Between Terminal 4 And 2 Of Main Relay

G06804587

Courtesy of HYUNDAI MOTOR CO.

Is the measured resistance within specification?
YES
- Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM.
NO
- Substitute with a known - good Main relay and check for proper operation. If the problem is corrected, replace Main relay and go to "VERIFICATION OF VEHICLE REPAIR " procedure.