Power Circuit Inspection

IG "OFF"
Disconnect Main Relay
IG "ON" & ENG "OFF".
Measure voltage between harness terminal 2 of Main Relay and chassis ground.
Measure voltage between harness terminal 5 of Main Relay and chassis ground.
Specification: Approx. B+

Fig 1: Measuring Voltage Between Harness Terminal 5 Of Main Relay And Chassis Ground
Courtesy of HYUNDAI MOTOR CO.
Is the measured voltage within specification?
YES
- Go to "CONTROL CIRCUIT INSPECTION " procedure.
NO
- Check fuse between battery and main relay is disconnected.
- Repair or replace open or short in harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.