Repair procedures (A4CF2): Installation

Connect the main harness connector (A) to the valve body.
CAUTION: When connecting the oil temperature connector, check the connector for rust, dirt, or oil, then reconnect it.

Fig 1: Connecting Main Harness Connector To Valve Body
Courtesy of HYUNDAI MOTOR CO.
Install the valve body. (Refer to appropriate Automatic Transaxle Reassembly Overhaul article )
Tightening torque:

10~12 Nm (1.0~1.2 kgf.m, 7~8 lb-ft)
Install the oil filter.
Tightening torque:

5~7 Nm (0.5~0.7 kgf.m, 4~5 lb-ft)
Continue to apply liquid gasket at application points at the oil pan with Ø0.098in (2.5mm) thickness.
Liquid gasket Part name : Three bond 1281B

Fig 2: Identifying Liquid Gasket Application Points
Courtesy of HYUNDAI MOTOR CO.
Tighten the mounting bolt with the specified TORQUE after installing the oil pan.
Tightening torque:

10~12 Nm (1.0~1.2 kgf.m, 7~8 lb-ft)
Install the drain plug.
Tightening torque:

35~45 Nm (3.5~4.5 kgf.m, 25~32 lb-ft)
Installation is the reverse of the removal.