LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2010 >> Genesis 4.6 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Immobilizer Control System >> DTCS With Programmable Interface Controller (Pic) >> P1694 Immobilizer-EMS Message Error >> Monitor Scantool Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor Scantool Data

  1. Check status
    1. IG "ON" & Engine "OFF"
    2. Monitor the "ECU, KEY and Smartra STATUS" Parameter on the Scantool.

      Specification:  'LEARNT'

      Fig 1: Scan Tool Display - "ECM Status" Parameter
      G06102254Courtesy of HYUNDAI MOTOR CO.
    3. Are "KEY STATUS", "SMARTRA STATUS" and "ECU STATUS" Parameter within specifications?

      YES 

      • Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, damage on the ECM or SMARTRA. And this DTC has not erased in previous repair. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

scientia non olet · About LEMON Manuals