Component Inspection

Check SMARTRA
1. IGN "ON" & Engine "OFF"
2. Neutralize SMARTRA with scantool.
3. Neutralize ECM and Register transponder key by scantool.
  NOTE: Pin code is required to Neutralize SMARTRA & ECM and to Register transponder key
4. Are Neutralizing and Registering Key completed normally?
  YES
  - Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, damage on the ECM or SMARTRA. Or it has not erased this DTC in previous repair. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  NO
  - Substitute with a known-good SMARTRA and perform the Key teaching.
    If the problem is corrected, replace SMARTRA and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    
    NOTE: If the SMARTRA3 is only replaced using an existing key and ECM, after replacing the "virgin" or "neutral" SMARTRA3, reteaching is possible by key Learning mode of GDS. In this case, all existing key must be retaught.
    
    If SMATRA3 is replaced to another one (used at other vehicle), it can only recycle its neutralized first before replacing.